Table of Contents
Advertisement
2.8
CompactFlash disk (CN13)
The PCM-3345 series is equipped with a CompactFlash disk socket on
the solder side, which supports the IDE interface CompactFlash disk
card. The socket itself is specially designed to prevent any incorrect
installation of the CompactFlash disk card. When installing or remov-
ing the CompactFlash disk card, please make sure that the system
power is off.
The CompactFlash disk card is defaulted as the E disk drive in your PC
system. The maximum capacity of Advantech's CFC is 40 MB. To fit
the Advantech CFC into the PCM-3345, simply plug it into the
designated connector. It will only fit when the red triangle on the CFC
is aligned with the triangle on the connector. The card will not fit any
other way (do NOT use force).
2.9
Floppy drive connector (CN1)
You can attach up to two floppy drives to the the PCM-3345's
on-board controller. Any combination of 5¼" (360 KB and 1.2 MB)
and/or 3½" (720 KB, 1.44 MB, and 2.88 MB) drives is possible.
A 34-pin daisy-chain drive connector cable is required for a dual-
drive system. A 34-pin flat-cable connector is fitted on one end of the
cable, while the other end has two sets of floppy disk drive connec-
tors. Each set consists of a 34-pin flat-cable connector (for the 3½"
drives), and a printed-circuit board connector (for the 5¼" drives).
Chapter 2 Installation
1 7
Advertisement
Table of Contents
