Table of Contents
Advertisement
4.1
Introduction
The PCM-3345 has an on-board VGA interface. The specifications
and features are described as follows:
4.1.1 Chipset
The PCM-3345 uses a SGS Thomson STPC for its SVGA controller,
which supports conventional analog CRT monitors. In addition, it also
supports interlaced and non-interlaced analog monitors (color and
monochrome VGA) in high-resolution modes while maintaining
complete IBM VGA compatibility. Digital monitors (i.e. MDA, CGA,
and EGA) are NOT supported. Multiple frequency (multisync)
monitors are handled as if they were analog monitors.
4.1.2 Display memory
With 512 K ~ 4 MB share memory, the VGA controller can drive
CRT displays or color panel displays with resolutions up to 1024 x
768 at 64 K colors.
4.2
Installation of SVGA driver
Complete the following steps to install the SVGA driver. Follow those
procedures in the flow chart that apply to the operating system which
you are using within your PCM-3345.
Important: The following windows illustrations are examples
Note 1:
Note 2:
3 6
PCM-3345 User's Manual
only. You must follow the flow chart instructions and
pay attention to the instructions which then appear
on your screen.
The CD-ROM drive is designated as "D" throughout
this chapter.
<Enter> means pressing the "Enter" key on the
keyboard.
Advertisement
Table of Contents
