System Test And Initialization; System Configuration Verification - Advantech PCM-3345 Manual

3.1

System test and initialization

These routines test and initialize board hardware. If the routines
encounter an error during the tests, you will either hear a few short
beeps or see an error message on the screen. There are two kinds of
errors: fatal and non-fatal. The system can usually continue the bootup
sequence with non-fatal errors. Non-fatal error messages usually
appear on the screen along with the following instructions:
press <F1> to RESUME
Write down the message and press the F1 key to continue the bootup
sequence.

3.1.1 System configuration verification

These routines check the current system configuration against the
values stored in the board's CMOS memory. If they do not match, the
program outputs an error message. You will then need to run the
BIOS setup program to set the configuration information in memory.
There are three situations in which you will need to change the CMOS
settings:
1. You are starting your system for the first time.
2. You have changed the hardware attached to your system.
3. The CMOS memory has lost power and the configuration informa-
tion has been erased.
The PCM-3345's CMOS memory has an integral lithium battery
backup. The battery backup should last at least ten years in normal
service. When it finally runs down, you will need to replace the
complete unit.
2 4 PCM-3345 User's Manual