Error Code Chart - Horizon Fitness PF-P3100 Manual

2 Service Mode and Error Code

2 - 2 Error Code Chart

Error
Code
[Cause] The fold section cover opens while the motor rotates. (The S10 fold section cover switch turns Off.)
E1
[Solution] Close the fold section cover. If the same error still occurs, check wiring/connection between S10 and QPM-243. If the S10 fold section cover switch is On,
LED L27 on QPM-243 turns off. If the same error still occurs, replace S10. If the same error still occurs, replace the QPM-243 control board.
[Cause] The X20 buckle connector is removed while the motor rotates. (The buckle chute is removed from the X20 buckle connector.)
E2
[Solution] Insert the buckle chute so that the X20P connector on the buckle chute is connected to the X20R connector on the folder correctly. If the same error still
occurs, check wiring/connection between X20 and QPM-243. If the buckle chute is inserted properly, LED L26 on QPM-243 lights. If the same error still
occurs, replace the QPM-243 control board.
[Cause] The A10 motor driver alarms. (The M10 main motor is overloaded.)
E3
[Solution] Check if a sheet is not caught between the mechanical sections driven by the M10 main motor. Check if the drive shaft of the M10 main motor tries to rotate
when the power is applied. Check if the drive shaft of the M10 can be rotated smoothly by hand when the drive belt is removed. If it is OK, check wiring/con-
nection between M10 and A10, and A10 and QPM-243. If it is OK, replace the A10 motor driver. If it is OK, replace the QPM-243 control board.
[Cause] The F2 fuse (3.15 A) on the QPM-243 control board is blown. (24VDC circuit from the control board shorts out, or the fuse is deteriorated.)
E4
[Solution] Check if the wiring is not caught in the machine covers and does not short out. Replace the F2 fuse. (If the fuse is not blown, LED L24 on QPM-243 lights.)
[Cause] The third and fourth contact point for the K01 interlock relay is welded. (Short-out condition) ---------- The interlock relay is defective.
E5
[Solution] Replace the K01 interlock relay.
[Cause] The third and fourth contact point for the K01 interlock relay is not connected. (Open condition) ---------- The interlock relay is defective.
E6
[Solution] Replace the K01 interlock relay.
2
Service Mode and Error Code
Cause and Solutions
2 - 2 Error Code Chart
2-3