Connecting The Device; Notes On Connecting - Siemens SIMATIC IPC127E Operating Instructions Manual

Hide thumbs Also See for SIMATIC IPC127E:
Table of Contents

Advertisement

3.3

Connecting the device

3.3.1

Notes on connecting

Risk of fire and electric shock
The on/off switch does not isolate the device from the power supply. Risk of electric shock if
the device is opened incorrectly or defective. There is also a risk of fire if the device or
connecting lines are damaged. Death or serious bodily injury can result.
You should therefore protect the device as follows:
• Always pull out the power plug when you are not using the device or if the device is
• Connect the device to a protective conductor as instructed (see "Connecting the
• Use a central power isolating switch for cabinet installation.
• When you install the device, make sure that the disconnector is easily accessible.
Risk of lightning strikes
A lightning flash may enter the mains cables and data transmission cables and jump to a
person.
Death, serious injury and burns can be caused by lightning.
Take the following precautions:
• Disconnect the device from the power supply in good time when a thunderstorm is
• Do not touch mains cables and data transmission cables during a thunderstorm.
• Keep a sufficient distance from electric cables, distributors, systems, etc.
NOTICE
Fault caused by I/O devices
The connection of I/O devices can cause faults in the device.
The result may be personal injury and damage to the machine or plant.
Note the following when connecting I/O devices:
• Read the documentation of the I/O devices. Follow all instructions in the documentation.
• Only connect I/O devices which are approved for industrial applications in accordance
• I/O devices that are not hotplug-capable may only be connected after the device has
SIMATIC IPC127E
Operating Instructions, 01/2019, A5E44296915-AA
WARNING
defective. The power plug must be freely accessible.
protective conductor").
WARNING
approaching.
with EN 61000-6-2 and IEC 61000-6-2.
been disconnected from the power supply.
Mounting and connecting the device
3.3 Connecting the device
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents