Mounting On A Standard Rail - Siemens SIMATIC IPC127E Operating Instructions Manual

Mounting and connecting the device
3.2 Mounting the device
3.2.2

Mounting on a standard rail

Mounting on a standard rail is suitable for horizontal and vertical mounting of the device.
Requirement
● A SIEMENS 35 mm standard rail TH35-15 conforming to EN 60715:2001
The standard rail is mounted.
● A standard rail bracket
Note
Only use the supplied screws for fastening the standard rail bracket. Longer screws can
damage the inside of the device.
Tools
● A T10 screwdriver
Procedure for mounting
26
1. Lay the standard rail bracket on the rear of
the device. Note the position of the spring
of the standard rail bracket.
2. Fasten the standard rail bracket with the
four supplied screws.
3. Place the device with the standard rail
bracket onto the mounting rail from above.
If the device is tilted when you place it
down, the standard rail bracket does not
grip.
4. Press the device down and toward the
standard rail until the standard rail bracket
engages.
5. Check whether the device is seated firmly
on the standard rail.
6. For vertical mounting on a standard rail:
Fasten a standard rail ground terminal be-
low the device.
Operating Instructions, 01/2019, A5E44296915-AA
SIMATIC IPC127E