Siemens SIMATIC IPC127E Operating Instructions Manual page 49

Tools
You can change the battery with the following tools:
● T20 screwdriver
● T10 screwdriver
● T8 screwdriver
● Allen wrench, width across flats 1.5 mm
Removing the SSD
To remove the SSD, follow these steps:
1. Remove the protective conductor connection.
2. Remove the screws on the two connection sides
3. Remove the threaded pin
4. Remove the remaining screws
5. Slide the heat sink out in the direction of the arrow, and rest the enclosure part on the
cooling fins.
6. Remove the marked screw and carefully pull out the SSD from the plug in the direction of
the arrow.
SIMATIC IPC127E
Operating Instructions, 01/2019, A5E44296915-AA
①
on the heat sink.
②
on the heat sink.
Device maintenance and repair
5.4 Replacing the SSD
③
and remove the covers.
49