Figure 7-3 Dp Slave Properties - Siemens SIMATIC S7-400H System Manual

Example:
The example of the process image partition 3 "TPA 3" below shows a possible configuration
in HW Config:
● TPA 3 at output: Those 50 bytes are stored consistently in process image partition 3
● Selecting "Process Image Partition -> ---" under Input in the pulldown menu means:
Figure 7-3
S7-400H
System Manual, 09/2007, A5E00267695-03
(pulldown list "Consistent over > entire length"), and can thus be read by means of
standard "Load input xy" commands.
do not write data to the process image. You must work with the system functions
SFC 14/15.
DP slave properties
S7-400H in PROFIBUS DP mode
7.2 Consistent Data
77