Siemens SIMATIC S7-400H System Manual page 334

Function modules and communication processors supported by the S7-400H
FMs and CPs usable for distributed one-sided use
Note
You can use all the FMs and CPs released for the ET 200M with the S7-400H in distributed
and one-sided mode.
FMs and CPs usable for distributed switched use
Module
Communication processor CP 341–1
(point-to-point link)
Communication processor CP 342–2
(ASI bus interface module)
Communication processor CP 342–2
(ASI bus interface module)
Counter module FM 350–1
Counter module FM 350–2
Controller module FM 355 C
Controller module FM 355 S
High-speed boolean processor FM 352-5
Controller module FM 355-2 C
Controller module FM 355-2 S
NOTICE
One-sided or switched function and communications modules are
not synchronized in the fault-tolerant system if they are in pairs, e.g. two identical FM 450
modules operating in one-sided mode do not synchronize their counter states.
334
Order no.
6ES7 341–1AH00–0AE0
6ES7 341–1BH00–0AE0
6ES7 341–1CH00–0AE0
6ES7 341–1AH01–0AE0
6ES7 341–1BH01–0AE0
6ES7 341–1CH01–0AE0
6GK7 342–2AH01–0XA0
6GK7 343–2AH00–0XA0
6ES7 350–1AH01–0AE0
6ES7 350–1AH02–0AE0
6ES7 350–2AH00–0AE0
6ES7 355–0VH10–0AE0
6ES7 355–1VH10–0AE0
6ES7352–5AH00–0AE0
6ES7 355–0CH00–0AE0
6ES7 355–0SH00–0AE0
System Manual, 09/2007, A5E00267695-03
Release
Product release 3 or later
Product release 1 or later
with firmware V1.0.0
Product release 1 or later
with firmware V1.10
Product release 2 or later
with firmware V2.03
Product release 1 or later
Product release 2 or later
Product release 4 or later
Product release 3 or later
Product release 1 or later
with firmware V1.0.0
Product release 1 or later
with firmware V1.0.0
Product release 1 or later
with firmware V1.0.0
S7-400H