E Function Modules And Communication Processors Supported By The S7-400H - Siemens SIMATIC S7-400H System Manual

Function modules and communication processors
supported by the S7-400H
You can use the following function modules (FMs) and communication processors (CPs) on
an S7-400 automation system:
FMs and CPs usable centrally
Module
Counter module FM 450
Function module FM 458-1 DP
Communications processor
CP 441-1 (point-to-point link)
Communications processor
CP 441-2 (point-to-point link)
Communications processor
CP 443-1 Multi (Industrial Ethernet,
TCP / ISO transport)
Communications module
CP 443-5 Basic (PROFIBUS; S7
communication)
Communications module
CP 443-5 Extended (PROFIBUS;
master on PROFIBUS DP)
Communications module
CP 443-5 Extended (PROFIBUS
DPV1)
1) 2)
Communications module
CP 443-5 Extended (PROFIBUS
DPV1)
1) 2)
Only these modules should be used as external master interfaces on the PROFIBUS DP.
1)
These modules support DPV1 as external DP master interface module (complying with
2)
IEC 61158/ EN 50170).
S7-400H
System Manual, 09/2007, A5E00267695-03
Order no.
6ES7 450–1AP00–0AE0
6DD 1607-0AA1
6ES7 441–1AA02–0AE0
6ES7 441–1AA03–0XE0
6ES7 441–2AA02–0AE0
6ES7 441–2AA03–0XE0
6GK7 443–1EX10–0XE0
6GK7 443–1EX11–0XE0
6GK7 443–5FX01–0XE0
6GK7 443–5DX02–0XE0
1)
6GK7 443–5DX03–0XE0
6GK7 443–5DX04–0XE0
Release
Product release 2 or later
As of firmware 1.1.0
Product release 2 or later
Product release 1 or later
with firmware V1.0.0
Product release 2 or later
Product release 1 or later
with firmware V1.0.0
Product version 1 or higher
with firmware V2.6.7
Product version 1 or higher
with firmware V2.6.7
Product release 1 or later
with firmware V3.1
Product release 2 or later
with firmware V3.2.3
Product version 2 or higher
with firmware V5.1.0
Product version 1 or higher
with firmware V6.0
E
one-sided Redundant
Yes No
Yes Yes
Yes No
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
333