Group F4 Input Terminal - Inovance IS300S002-C User Manual

possibility of over voltage fault alarm. When there is brake resistor or it has
not need for fast deceleration, select "Enabled".
Oscillation suppression
F3-11 gain
Setup range
Select "0" for this gain when the motor has no oscillation. Only when the
motor has obvious oscillation and cannot run normally can this gain be
properly increased. The bigger the gain is, the better oscillation suppression
result will be. The method of selecting this gain is to select the smallest one
on the premise that there is effective oscillation suppression measure, so as
to ease the negative effect on the VF operation.

Group F4 Input Terminal

The standard unit of IS300 series driver has five multifunctional digital input
terminals (DI5 of which can be used as high-speed pulse input terminal) and
two analog input terminals. If the system needs more input/output terminals,
optional multifunctional input/output expansion card can be used.
The multifunctional input/output expansion card has 5 multifunctional digital
input terminals (DI6 to DI10) and 1 analog input terminal (AI4).
DI1
F4-00 function
selection
DI2
F4-01 function
selection
DI3
F4-02 function
selection
DI4
F4-03 function
selection
D15
F4-04 function
selection
terminal
Factory default
value
terminal
Factory default
value
terminal
Factory default
value
terminal
Factory default
value
terminal
Factory default
value
- 117 -
Factory
default value
0 ~100
Model
dependent
1
0
0
9
0