Pre-Dive Inspection - Aqua Lung Rapid Diver User Manual

22

PRE-DIVE INSPECTION

Before each use, your BC must be given a thorough visual inspection and
functional test. NEVER dive with a BC that shows signs of damage to any of
it's components until it has received a complete inspection and service from an
authorized Aqua Lung Dealer or Distributor.
1. Visually inspect the entire BC for cuts, punctures, frayed seams, excessive
abrasion, damaged or missing hardware and other damage of any kind.
2. Connect the power inflator to a source of clean air, via the MP quick disconnect
hose. Depress and release the inflator button intermittently to ensure that the
airflow is unobstructed and that the airflow stops completely when the button is
released (See Inflation Methods).
3. Manually operate each dump valve by pulling on the pull knob and cord assembly
to release air from inside the BC, then fully inflate the BC until the (OPRV) opens
(See Deflation Methods). Examine the operation of the (OPRV) / dump valve by
repeatedly inflating the BC to ensure the valve opens to relieve excess pressure,
yet closes immediately afterwards to allow the bladder to remain taut and fully
inflated.
4. Check the function of the oral inflator button and inflator dump valve (See
Deflation Methods) to ensure a rapid and unobstructed exhaust from each
valve. Fully inflate the BC once again and disconnect the MP hose from the
power inflator. Let the BC stand for 10 minutes and listen for any leaks.
WARNING: If you can hear any leaks or if the bladder begins to deflate within 10
minutes, DO NOT attempt to use the BC until it has received a complete inspection
and service.
5. Make a final check of the cylinder band tension to ensure it has been secured
properly. Re-tighten if necessary.
NOTE: See product specific manual for pre-dive inspection instructions of equipment
not covered in this manual (regulator, gauges, cylinder).
Rapid Diver™ User's Manual