Aqua Lung Rapid Diver User Manual page 12

12
3. The procedure for weaving the cylinder band through the cam buckle is covered
in Threading the Cam-Buckle section of this manual.
4. Open the cylinder band buckles and loosen the bands.
5. Slide the cylinder band over the cylinder
so the soft pack is at the desired position in
relation to the cylinder valve. Make sure the
cylinder valve air outlet is facing the back of
the soft pack (Fig. 9).
6. The procedure for securing the cylinder band to the cylinder is covered in
Securing the Band to the Cylinder section of this manual.
7. Assemble the regulator first stage to the cylinder valve (See manual provided
with regulator for attachment instructions).
NOTE: When using the Rapid Diver System with a rear mount cylinder set up, a
standard SCUBA regulator configuration must be used.
8. Connect the MP inflator hose and secure it in place using the hook and
loop attachment (Fig. 5f). The procedure for connecting the MP inflator hose
is covered in the Inflation Methods section of this manual.
9. Slowly pressurize the system while carefully listening for leaks. If any leaks
are detected, do not dive with your Rapid Diver System until the source of the
leak has been corrected.
Rapid Diver™ User's Manual
Fig. 9