Aqua Lung Rapid Diver User Manual page 11

Rear Mount Assembly
A cylinder can be attached vertically to the soft pack on the rear of the Rapid
Diver Pro BC (Fig. 6). This configuration allows for larger cylinders to be used
when needed.
1. Place the soft pack on a flat surface
with the rear cylinder mount face-up
(Fig. 6).
NOTE: The long cylinder bands must be used to set-up a rear cylinder mount configuration.
2. Position the ribbed side of the traction sleeve face up. Insert the open end
of the cylinder band into left side of the traction sleeve, under the rear cylinder
mount straps and out the right side of the traction sleeve (Fig. 7). The traction
sleeve should be positioned directly over the rear cylinder mount (Fig. 8). Repeat
process for other cylinder band.
Fig. 7
Rear Cylinder
Mount
Fig. 6
Fig. 8
11