Pci Board Installation - Pro-face PS-3650A Series Hardware Manual

(3) Install the Main Memory where the following figure shows. Insert the optional DIM module into the
connector completely, then gently press it downward until it is locked into the stopper.
(4) Reinstall the Memory Slot Cover and attach with two screws. The torque required to tighten these
screws is 0.5 to 0.6N•m.
3.2.2

PCI Board Installation

A PCI board, commercially available, can be installed on the PS-3650A Series unit.
• The maximum size allowed for a PCI board is 174.63mm [6.88in.] × 106.68mm [4.2in.].
(1) Turn OFF the power switch of the PS-A unit and remove the power cable. Place the PS-A unit on a flat,
level surface facing the display face downwards
(2) Unscrew a screw of the Expansion Board Support and remove the Expansion Board Support.
Main Memory (DIM Module)
Chapter 3 Installation and Wiring
Connector
Main Memory
1
2
Stopper
3-9