Table of Contents
Advertisement
Running the Diagnostics
sequence from a terminal, specify only the command letter that
denotes the given test sequence.
default test sequence, type only the letter d and press the
RETURN key.
Appendix A lists the test sequences that include multiple tests.
SPECIAL HARDWARE REQUIREMENTS
There are two special hardware requirements for running System
6300 Computer diagnostics:
1.
To use a terminal, attach the terminal via a cable
containing a line for data set ready (D S R ) to the RS-
232-C port.
terminal is connected.
2.
To run the RS-232-C tests, connect a terminator plug for
each RS-232-C port that you test.
executing in attended mode, the only requirement is
connector B with the following connections:
pin 2 : to pin 3
pin 4 to pin 5
pin 8 to pin 20.
LOADING THE DIAGNOSTICS
W i t h
the
w o r k s t a t i o n d o w n l o a d e d
f o l l o w i n g
s t e p s
1.
P o wer
o n .
2.
I n s e r t
the
p r o g r a m
3.
W a i t
for the d i s k
4.
Press
the
1-2
The diagnostics use DSR to determine that a
to l o a d s
the
d i a g n o s t i c s :
f l o p p y d i s k e t t e
in the
a p p r o p r i a t e
to i n i t i a l i z e .
R E S E T b ut t o n .
For example, to execute the d
On a basic system
and w o r k i n g ,
use the
c o n t a i n i n g
the d i a g n o s t i c
d r i v e
and c l o s e the d o or.
Advertisement
Table of Contents
