Safety Information - Landis+Gyr ULTRACOLD 2WR6 Series Manual

Safety information

2 Safety information
The meter may only be used in building service engineer-
ing systems and only for the applications described.
The local regulations (installation etc.) must be adhered to.
Adhere to the operating conditions according to the dial
plate during use. Non-adherence can cause hazards and
the warranty will expire.
Adhere to the requirements regarding circulating water
(CEN / TR 16911:2016).
The meter is only suitable for circulating water in heating
systems.
The meter is not suitable for potable water.
Do not lift the meter by the electronic unit.
Be aware of sharp points on the thread, flange and meas-
uring tube.
Only personnel, trained in the installation and operation of
meters in heating and cooling systems, may install and
remove the meter.
Only install or remove the meter when the pipes are de-
pressurized.
After installing the meter, check the leak-tightness of the
system.
Warranty and calibration validity will lapse if the calibration
relevant security seal is broken.
Only clean the meter from outside with a soft, lightly wetted
cloth. Do not use any spirit or cleaning solvent.
As far as disposal is concerned, the meter is a waste elec-
tronic appliance in the sense of European Directive
2012/19/EU (WEEE) and it must not be disposed of as
domestic waste. The relevant national, legal regulations
must be observed as the appliance must be disposed of
via the channels provided for this purpose. The local and
currently valid legislation must be observed.
The meter contains lithium batteries. Do not dispose of the
meter and the batteries with domestic waste. Observe the
local stipulations and laws on disposal.
5/21