King Industrial KC-366SH Instruction Manual page 8

INSTALLING/REMOVING SPINDLE
Spindle Assembly Installation
The fence guard (A) Fig.11 has been removed for clarity. The spindle assembly
(B) is mounted to the arbor (C) and secured with a draw bar (D) and nut (E).
Use the following procedure to install the spindle assembly. Reverse the order to
remove the spindle.
Warning: When changing tools, making adjustments, or doing clean-up and
maintenance, always turn the machine off and unplug the machine from its
power source.
1. Raise the arbor (C) all the way up using the handwheel located on the front of
the cabinet.
Locking the Arbor
2. Locate the spindle lock (A) Fig.12 accessible through the door on the right
side of the cabinet. Pull out and rotate 90º right or left resetting the knob into
the indent. Turn the arbor (C) by hand until it locks, then verify that it will not
rotate.
Installing the Spindle Assembly
3. Thread the nut (E) Fig.11 onto the threaded end of the spindle (D) as shown.
Tighten securely by hand.
4. Thread the spindle assembly (B) Fig.11 and nut (E) onto the arbor (C) and
hand tighten only.
5. Insert the draw bar (B) Fig.12 through the opening in the shaft (C) just below
the drive belt (D). Turn clockwise, fastening and securing it to the spindle.
Tighten the draw bar (B) with the provided large wrench (E).
6. Tighten the nut (E) Fig.11 with the large wrench (E) Fig.12.
Note: At this time, the spindle lock is still locked.
Spindle Assembly Removal
The spindle lock must be engaged to remove spindle assembly.
1. Remove the draw bar (B) Fig.12.
2. Loosen the nut (E) Fig.11 then, using the wrench (E) Fig.12 continue to turn
until the spindle can be removed from the arbor.
SHAPER CUTTER INSTALLATION
Warning: When changing tools, making adjustments, or doing clean-up and
maintenance, always turn the machine off and unplug the machine from its
power source.
Locking the Spindle and installing shaper cutter
1. Locate the spindle lock (A) Fig.12 accessible through the door on the right
side of the cabinet. Pull out and rotate 90º right or left resetting the knob into
the indent. Turn the arbor (C) by hand until it locks, then verify that it will not
rotate.
2. Place the shaper cutter (A) Fig.13 (not included) onto the spindle as shown,
oriented in the proper direction.
3. Place the spacers (B) and keyed collar (C) onto the spindle.
Note: Spacers come in several widths and the stacked selection (B) must be
such that the top of the keyed collar (C) sits slightly above the top of the spindle
(D). This will ensure sufficient pressure to properly secure the shaper cutter (A)
when installation is complete.
4. Install the pronged washer (E) and cap screw (F). Tighten cap screw with the
8 mm hex. key provided.
ASSEMbLY & ADJUSTMENTS
FIGURE 11
FIGURE 12
FIGURE 13