Larius Pegaso Operating And Maintenance Instructions Manual page 23

6) Start the machine, switch (F) on "1";
Start the pump, switch (G) on "ON".
Slightly increase the pressure of the
pump by rotating the potentiometer (H)
clockwise, the reading of the value is
shown on the upper display (photo 6).
7) With one hand, take the hose and with
the pump rotating, pull to extract it
(photo 7).
ASSEMBLY
1) Before inserting the hose, spread some silicon
based grease on the surface (photo 8).
2) With the pump still rotating, insert the hose on the
side from which it was removed (photo 7).
Push the hose until it is completely inserted, it must
fit into the upper hose holdere.
☞
PLEASE NOTE: In order to facilitate the opera-
tion, push the mouth of the hose with the palm
of your hand, so as to close it (photo 9).
3) Turn the pump off and disconnect the power supply
to the machine;
4) At this point:
• reassemble and lock the upper metal clamp;
• reinsert the lower metal clamp on the hose;
• insert the product passage hose, attach the plate
to the structure with the same bolts that you
previously removed;
• lock the lower metal clamp;
• reassemble the side casing.
PEGASO
21
Photo 7
Photo 8
Photo 9