REGOLATIONS
P
FLOW ADJUSTMENT
•
The flow of material must be adjusted at the sprayer
using the fluid flow regulator handle and the value is
shown on the display.
ADJUSTING THE AIR
•
In order to decrease the air flow, turn the regulator
anticlockwise (P1).
•
In order to increase the air flow, turn the regulator
clockwise (P1).
•
Air passage opening and closing tap (P2).
NOZZLE SELECTION
•
To select correct nozzle for your applications, consider
size of aggregate in material and coarseness of spray
pattern. Remember the larger the nozzle, the larger
the pattern (P3).
MATERIAL FLOW ADJUSTMENT
•
Test spray pattern on card-board. Hold gun 18 to 30 in.
(500 to 700 mm) from surface. Use this spray distance
for most applications.
•
Always proceed with regular strokes and circular
movements, overlap the strokes by 50%.
•
Check the evenness of the material often and dilute
with water if necessary in order to maintain the suitable
level of evenness.
•
Material flow should be adjusted on the sprayer using
the Fluid Flow Regulator knob.
•
Engage trigger lock to hold trigger open and reduce
fatigue.
PEGASO
15
10
12
500-700 mm