Out-Of-Band Management (Oobm) Port; Back Of The Switches - Aruba 2930M Installation And Getting Started Manual

To accomplish this:
Restore the factory default
configuration
NOTE: These buttons are provided for your convenience. If you are concerned with switch
security, make sure that the switch is installed in a secure location, such as a locked wiring closet.
You can also disable these buttons by using the front-panel-security command. See the
2930M Management and Configuration Guide for a description of that command.

Out-of-band management (OOBM) port

This RJ-45 port is used to connect a dedicated management network to the switch. To use it, connect an RJ-45
network cable to the management port to manage the switch through Telnet from a remote PC or a UNIX
workstation.
To use this port, the switch must have an IP address. IP settings can be configured through a console port
connection or automatically from a DHCP/Bootp server.
A networked out-of-band connection through the management port allows you to manage data network switches
from a physically and logically separate management network.
For more information, see the Network Out-of-Band Management (OOBM) appendix in the Management and
Configuration Guide at https://www.hpe.com/networking/support.

Back of the switches

The back of all 2930M switches is the same.
Figure 4: Back of the 2930M switches
Table 8: Back of the 2930M switches: Label and description
22
1. Press Clear and Reset
simultaneously.
2. While continuing to press Clear,
release Reset.
3. When the Global Status LED
begins to fast flash orange (after
approximately 5 seconds), release
Clear.
Label
1
2
3
4
Do this:
AC power connector / power supply slot 1
AC power connector / power supply slot 2
Stacking module slot
Uplink module slot
This will happen:
The switch removes all
configuration changes, restores the
factory default configuration, and
runs self test.
Description
Aruba 2930M Switches