Ground The Chassis - Cisco Firepower 2100 Series Hardware Installation Manual

Ground the Chassis

Figure 40: Inner Rail Release Clip
1
Step 7 Use the captive screws on the front of the mounting brackets to fully secure the chassis to the rack.
What to do next
Continue with the following procedures:
•
•
•
•
Ground the Chassis
Take note of the following warnings:
Warning
Statement 1024—Ground Conductor
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available.
Cisco Firepower 2100 Series Hardware Installation Guide
54
Inner rail release clip
Ground the Chassis, on page 54
Connect Cables, Turn on Power, and Verify Connectivity for Cisco Firepower Threat Defense, on page
57
Connect Cables, Turn on Power, and Verify Connectivity Using Cisco Firepower Management Center,
on page 60
Connect Cables, Turn on Power, and Verify Connectivity for Cisco ASA, on page 62
2 Inner rail attached to chassis
Mount and Connect