Cisco Firepower 2100 Series Hardware Installation Manual page 62

Connect Cables, Turn on Power, and Verify Connectivity for Cisco Firepower Threat Defense
Warning
Statement 1025—Use Copper Conductors Only
Use copper conductors only.
After rack-mounting and grounding the Firepower 2100, follow these steps to connect cables, turn on power,
and verify connectivity.
Note
The following figure shows the default configuration using a management computer connected to the inside
network. Your deployment may vary depending on your basic logical network connectivity, ports, addressing,
and configuration requirements.
Figure 43: Connect Cables to Firepower 2100 Interfaces
1
3
5
7
Cisco Firepower 2100 Series Hardware Installation Guide
58
(Alternative) Management 1/1
192.168.45.45
Internet
Management computer (DHCP from inside
192.168.1.x)
Other data networks (SFP/SFP+
transceivers)
2 WAN modem
4 Ethernet 1/1 (outside, DHCP from modem)
6 Ethernet 1/2 (inside 192.168.1.1)
Mount and Connect