Replacing A Chassis Intrusion Switch - Cisco SE-CL-L3 Installation Manual

Replacing a Chassis Intrusion Switch

Figure 43: mRAID Riser (Internal Riser 3) Location
1 External blue handle
2 Two pegs on inner chassis wall
Replacing a Chassis Intrusion Switch
The chassis intrusion switch in an optional security feature that logs an event in the system event log (SEL)
whenever the cover is removed from the chassis.
Step 1 Prepare the server for component installation:
a) Shut down and remove power from the server as described in
on page 27.
b) Slide the server out the front of the rack far enough so that you can remove the top cover. You might have to detach
cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the rack.
Caution
c) Remove the top cover from the server as described in
Step 2 Remove an existing intrusion switch:
a) Disconnect the intrusion switch cable from the socket on the motherboard.
b) Use a #1 Phillips-head screwdriver to loosen and remove the single screw that holds the switch mechanism to the
chassis wall.
c) Slide the switch mechanism straight up to disengage it from the clips on the chassis.
Cisco Application Services Engine Hardware Installation Guide
76
3 Card-ejector lever
-
Shutting Down and Removing Power From the Server,
Removing the Server Top Cover, on page
Maintaining the Server
28.