Cisco Firepower 2100 Series Hardware Installation Manual page 30

SSDs
The Firepower 2130 and 2140 have a removable fan tray with 3 + 1 redundant fans that are hot-swappable.
The fan tray is installed in the rear of the chassis. Any one fan can fail indefinitely and the system continues
to function. When a fan fails, the remaining fans automatically spin up to full speed.
The fan LED is located on the front of the chassis. See
associated with the 2100 series fans.
For More Information
• See
• See
SSDs
The Firepower 2110 and 2120 have two SSD slots. These models ship with one 100-GB SSD installed in slot
1. The Firepower 2130 and 2140 have two SSD slots. These models ship with one 200-GB SSD installed in
slot 1. See
You can use the second SSD slot to upgrade to the MSP. The MSP must be installed in the second slot. The
second SSD slot remains empty unless you install the MSP in the second slot. The MSP stores threat detection
results for use in future analysis. It supports the Advanced Malware Protection (AMP) software feature. It is
used as both storage and as the Malware application repository. RAID is not supported.
Caution You cannot swap SSDs between different Firepower platforms. For example, you cannot use a 4100 series
SSD in a 2100 series security appliance.
Note The 100-GB SSD is restricted to the 2110 and 2120 models. The 200-GB SSD is restricted to the 2130 and
2140 models. Do not mix them.
Although the hardware supports hot swapping for the SSDs, the software does not, so you must power down
the chassis before removing and replacing them.
For More Information
• See
• See
Supported SFP/SFP+ Transceivers
Take note of the following warnings:
Cisco Firepower 2100 Series Hardware Installation Guide
26
Front Panel LEDs, on page 10
Remove and Replace the Fan Tray, on page 78
fan tray.
Product ID Numbers, on page 30
Front Panel LEDs, on page 10
Remove and Replace the SSD, on page 68
Product ID Numbers, on page 30
for the location and description of the fan LED.
for the procedure for removing and replacing the
for a list of the PIDs associated with the 2100 series SSDs.
for the location and description of the SSD LEDs on the front panel.
for the procedure for removing and replacing the SSD.
Overview
for a list of the PIDs