Adding A Wireless Rim To A Fusion Loop Module - EMS FCZ-170-111 Programming Manual

Adding a Wireless RIM to a Fusion Loop Module

Take the device to the Loop Module and follow the steps below:
With the loop module in its normal state, the screen will display:
Press the rotary control and the screen will display:
Turn the rotary control until the screen displays:
Press the rotary control and the screen will display:
Press the device's log on button for 2 seconds (the device's
con rmation LED will illuminate). The screen will display:
If the ident shown does not match the ident of the new device to be added, press the rotary
control (with the above Add Dev xxxxx N? display shown). This will return the display to the
previous menu.
If the device ident is correct, turn the rotary control until the
screen displays:
Press the rotary control and the screen will display:
Followed by:
Turn the rotary control, until the desired device address is shown:
Press the rotary control to con rm the device address. The screen
will display:
Press the BACK button, to return to the front display:
©2018 EMS Ltd. All rights reserved. Page 5 of 24
DEV01 AL00 FT00
Device Status
Add New Device
Press Dev Log On
Add Dev xxxxx N?
Add Dev xxxxx Y?
Adding
Address 002
Address 007
I/O Added
DEV02 AL00 FT00
TSD115 Iss2 17/09/2018 AJM