Introduction; Tools - EMS FCZ-170-111 Programming Manual

Introduction

The FireCell Wireless Remote Indicator Module (RIM) is compatible with both the EMS FireCell
system and the EMS Fusion Loop Module.
It is possible to add (log on) the RIM to the FireCell system both manually and via FireCell
Con guration Tool software, whilst the RIM must be added to the Fusion Loop Module manually.
All of the aforementioned methods are detailed in this programming guide.
Also covered within this guide is the adding (logging on) of RIMs to the FireCell control panel, via
the Loop Explorer computer software plus two methods of programming the cause and e ect
rules to link either, a zone of devices, or a single device to a RIM.
This guide has been written for engineers that have completed FireCell product training and
therefore have knowledge of the product and the basic programming functionality of the control
panel.
It is therefore assumed that the engineer is practised in the methodology of removing, editing
and sending Loop Explorer setup les to the FireCell control panel.
Note: screenshots shown in this programming guide depict FireCell Con guration Tool
version 60082 and Loop Explorer Version 3.0. Future software releases may vary both
visually and in operation.

Tools

Before starting the programming, the following items MUST be available.
Laptop c/w Loop Explorer software
FireCell control panel programming lead (FC-000-KEN)
©2018 EMS Ltd. All rights reserved. Page 3 of 24 TSD115 Iss2 17/09/2018 AJM