Local Users Folder; Remote Authentication Folder - Vertiv Liebert IntelliSlot Unity Card Installer And User Manual

Enable Auto-Sync to Managed Device
Enable automatic writing time to the managed device.
Managed Device Auto-Sync Rate
Rate at which time will be written to the managed device, if an external time source has been
selected.

6.4.2 Local Users Folder

The Local Users subfolder offers up to 10 users and 3 access levels described in Table 5.1 below.
The default password for all users is Liebert (case-sensitive).
Table 5.1 User-access Levels
ACCESS/
LEVEL
PERMISSION
NAME
TYPE
No Access None
General User Read-only
Administrator Read/Write
IMPORTANT! Record user names and passwords and save them in a secure place where they can be
found if forgotten. A lost password cannot be retrieved from the IS-UNITY card. If the administrator
password is lost, the card must be reset to factory defaults and reconfigured.
To change the user names and passwords:
NOTE: 30-character maximum. All printable characters are valid except: \ : ' < > ~ ? " #
1. On the Communications tab, select Configuration > Local Users, then select the folder of the
user to configure.
2. Click Edit and enter the administrator user name and password, then click OK.
3. Enter a new user name and password.
4. Re-enter the password to confirm it.
5. In Authorization for User, select the type of access, see Table 5.1 above.
6. Click Save to confirm the changes or Cancel to discard them.

6.4.3 Remote Authentication Folder

The top level of the Remote Authentication subfolder displays the configured authentication type. The
implementation provides authentication and authorization at the remote server.
The folder contains subfolders for authentications types:
6 Editing the Unity Card Configuration
DESCRIPTION
The No Access level is enforced when "Password Protected Site" is enabled.
Able to view all tabs, folders and sub-folders of the user-interface.
A General User will only need to enter the assigned password if "Password Protected Site" is
enabled, see Web Server Folder on page 39.
By default, Local User [2] is User with the default password Liebert (both are case-sensitive). The
Authorization (access type) for Local User [2] is "General User."
Able to edit settings using the assigned password, which is always required to edit
settings/configuration.
By default, Local User [1] is Liebert with the default password Liebert (both are case-sensitive). The
Authorization (access type) for Local User [1] is "Administrator." Be sure that you always have one
administrator user, so you can access and modify configuration and other settings.
31