Delay Edit - Roland JD-XA Parameter Manual

Effects

DELAY Edit

Menu Parameter
[ K ] [ J ]
[Shift] +Cursor Cursor
Level
(Delay Level)
Switch
(Delay Switch)
Sync
(Delay Sync)
Time
(Delay Time)
*
This is valid only if
selected for Delay Sync.
Note
(Delay Note)
*
This is valid only if
selected for Delay Sync.
DELAY
(Delay)
Acceleration
(Delay Acceleration)
Feedback
(Delay Feedback)
HF Damp
(Delay HF Damp)
Low Gain
(Delay Low Gain)
High Gain
(Delay High Gain)
Value
[ K ] [ J ]
Value [-] [+]
0–127
OFF, ON
msec, NOTE
0–1300 ms (msec)
"msec" is
1/64T, 1/64, 1/32T, 1/32,
1/16T, 1/32., 1/16, 1/8T,
1/16., 1/8, 1/4T, 1/8., 1/4,
"NOTE" is
1/2T, 1/4., 1/2, 1/1T, 1/2.,
1/1, 2/1T, 1/1., 2/1
0–15
-98%–0–+98%
200 Hz, 250 Hz, 315 Hz,
400 Hz, 500 Hz, 630 Hz,
800 Hz, 1000 Hz, 1250
Hz, 1600 Hz, 2000 Hz,
2500 Hz, 3150 Hz, 4000
Hz, 5000 Hz, 6300 Hz,
8000 Hz, BYPASS
-15 dB–0–+15 dB
-15 dB–0–+15 dB
Explanation
Adjusts the volume of delay sound.
Switches the delay on/off.
"msec,"
If this is set to you can specify the DELAY Time in msec units.
"NOTE,"
If this is set to you can specify the DELAY Note in terms of a note value relative to the
tempo.
If Fx TempoSync is "ON," this indicates (NOTE), and operation is the same as when
specified.
Delay time from when the original sound is heard to when the delay sound is heard
Speed at which the current delay time changes to the specified delay time when you change
the delay time. The rate of change for the Delay Time directly affects the rate of pitch change.
Adjusts the amount of the delay sound that's fed back into the effect.
Negative (-) values invert the phase.
Adjusts the frequency above which sound fed back to the effect is filtered out.
If you do not want to filter out any high frequencies, set this parameter to BYPASS.
Amount of low-range boost/cut
Amount of high-range boost/cut
24
"NOTE" is