Od/Ds->Twah (Od/Ds 0 Touch Wah); Od/Ds->Awah (Od/Ds 0 Auto Wah) - Roland JD-XA Parameter Manual

Effects
51: OD/DS->TWah
L in
Overdrive/ Amp
Distortion Simulator
R in
Parameter Value
Drive Switch
OFF, ON
OVERDRIVE,
Type
DISTORTION
Drive #
0–127
Tone # 0–127
Amp Switch OFF, ON
SMALL, BUILT-IN,
AmpType
2-STACK, 3-STACK
Touch Wah Sw
OFF, ON
(Touch Wah Switch)
TWah FilterType
LPF, BPF
(Touch Wah Filter Type)
TWah Polar
DOWN, UP
(Touch Wah Polarity)
TWah Sens #
0–127
(Touch Wah Sens)
TWah Manual #
0–127
(Touch Wah Manual)
TWah Peak #
0–127
(Touch Wah Peak)
D100:0W–
TWah Bal #
D0:100W
(Touch Wah Balance)
Low Gain -15–+15 dB
High Gain -15–+15 dB
Level 0–127
(OD/DS 0 Touch Wah)
Touch 2-Band
Wah EQ
Explanation
Turns overdrive/distortion on/off
Type of distortion
Degree of distortion
Also changes the volume.
Sound quality of the effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Wah on/off
Type of filter
LPF: Produces a wah effect in a
broad frequency range.
BPF:
Produces a wah effect in a
narrow frequency range.
Sets the direction in which the
frequency will change when the
touch-wah filter is modulated.
UP: The filter will change toward a
higher frequency.
DOWN:
The filter will change toward
a lower frequency.
Sensitivity with which the filter is
modified
Center frequency at which the wah
effect is applied
Width of the frequency region at
which the wah effect is applied.
Increasing this value will make the
frequency region narrower.
Adjusts the volume balance
between the sound that is sent
through the wah (W) and the sound
that is not sent through the wah (D).
Amount of low-range boost/cut
Amount of high-range boost/cut
Output volume
52: OD/DS->AWah
L in
L out
Overdrive/
Distortion
R in
R out
Parameter
Drive Switch
Type
Drive #
Tone #
Amp Switch
AmpType
Auto Wah Sw
AWah FltType
(Auto Wah Filter Type)
AWah Manual #
(Auto Wah Manual)
AWah Peak #
(Auto Wah Peak)
AWah Sync
(Auto Wah Sync)
AWah Rate #
(Auto Wah Rate)
AWah Depth #
(Auto Wah Depth)
AWah Bal #
(Auto Wah Balance)
Low Gain
High Gain
Level
44
(OD/DS 0 Auto Wah)
Amp Auto 2-Band
Simulator Wah EQ
Value Explanation
OFF, ON Turns overdrive/distortion on/off
OVERDRIVE,
Type of distortion
DISTORTION
Degree of distortion
0–127
Also changes the volume.
0–127 Sound quality of the effect
OFF, ON Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
SMALL, BUILT-IN,
BUILT-IN: single-unit type amp
2-STACK, 3-STACK
2-STACK: large double stack amp
3-STACK: large triple stack amp
OFF, ON Wah on/off
Type of filter
LPF: Produces a wah effect in a
LPF, BPF broad frequency range.
BPF:
Produces a wah effect in a
narrow frequency range.
Center frequency at which the wah
0–127
effect is applied
Width of the frequency region at
which the wah effect is applied
0–127
Increasing this value will make the
frequency region narrower.
Hz:
The AWah Rate value is specified
in Hz.
Hz, NOTE
NOTE:
The AWah Rate value is
specified as a note value.
0.05–10.00 Hz, Rate at which the wah effect is
note modulated
Depth at which the wah effect is
0–127
modulated
Adjusts the volume balance
D100:0W– between the sound that is sent
D0:100W through the wah (W) and the sound
that is not sent through the wah (D).
-15–+15 dB Amount of low-range boost/cut
-15–+15 dB Amount of high-range boost/cut
0–127 Output volume
L out
R out