Roland JD-XA Parameter Manual page 19

TFX Parameters
Parameters that are affected by Limit Mode are indicated by a
Parameter Value
01: Flt+Drive
(FILTER+DRIVE)
A low-pass filter with overdrive. It cuts the high frequencies and adds distortion.
Cutoff
0–127
Resonance 0–127
Drive 0–127
02: Isolator
(ISOLATOR)
Isolates or removes the low, mid, or high frequency ranges.
0–127
Low
0–127
Mid
High 0–127
03: DJFX Looper
Loops a short portion of the input sound. You can vary the playback direction and playback speed of the input sound to add turntable-type effects.
Length 0–127
Speed -1.0–+1.0
Loop Sw OFF, ON
04: BPM Looper
Loops a short portion of the input sound.
0–127
Length
Timing
OFF, 1–8
Loop Sw OFF, ON
05: Bit Crush
(BIT CRUSH)
This creates a lo-fi sound.
Sample Rate
0–127
Bit 0–127
Filter 0–127
06: Wah
(WAH)
Produces a wah effect.
Peak 0–127
Rate 0–127
Manual 0–127
07: Reverb
(REVERB)
Adds reverberation to the sound.
Reverb Time 0–127
Tone 0–127
Balance D64–63E
08: Delay
(DELAY)
Repeats the sound.
Delay Time Note *1
0–127
Feedback
Balance D64–63E
09: Tape Echo
(TAPE ECHO)
Simulates a tape-type echo unit of the past.
Rate 0–127
Intensity 0–127
Balance D64–63E
Explanation
Adjusts the frequency that will be cut.
Adjusts peak frequency response at the cutoff frequency.
Adds distortion.
Isolates/removes the low-frequency range.
Isolates/removes the mid-frequency range.
Isolates/removes the high-frequency range.
(DJFX LOOPER)
Specifies the length of the loop.
Specifies the playback direction and playback speed.
Negative (-) settings make the sound play backward. Positive (+) settings make the sound play forward. With a value of
0.0, playback stops.
If you turn this on while sound is playing, the sound at that point will be looped. Turn this off to cancel the loop.
(BPM LOOPER)
Specifies the length of the loop.
Specifies the timing (in 8th note units) at which sounds looped during a measure will automatically start playing. If you
don't want the loop to play automatically, turn this
If you turn this on while sound is playing, the sound at that point will be looped. Turn this off to defeat looping.
Adjusts the sample rate.
Adjusts the bit depth.
Adjusts the filter depth.
Adjusts the width of frequencies to which effect is applied.
Adjust the speed of modulation.
Adjusts the pitch of the effect sound.
Adjusts the reverberation time.
Adjusts the tone of the reverberation.
Adjusts the volume balance between the direct sound and effect sound.
Adjusts the interval of the repeats.
Adjusts the number of the repeats.
Adjusts the volume balance between the direct sound and effect sound.
Specifies the tape speed.
Specifies the amount of echo repeat.
Adjusts the volume balance between the direct sound and effect sound.
symbol.
"OFF."
19
Effects