Ep->Tre (Ep Amp Sim 0 Tremolo); Ep->Cho (Ep Amp Sim 0 Chorus) - Roland JD-XA Parameter Manual

57: EP->Tre
(EP Amp Sim 0 Tremolo)
L in
EP Amp
R in
Parameter Value
OLDCASE,
Type NEWCASE,
WURLY
Bass # -50–+50
Treble #
-50–+50
Tremolo Sw #
OFF, ON
(Tremolo Switch)
Trem Sync
Hz, NOTE
(Tremolo Sync)
0.05–10.00 Hz,
TremRate #
note
(Tremolo Rate)
TremoloDepth # 0–127
Tremolo Duty -10–+10
SpType LINE, OLD, NEW,
WURLY, TWIN
(Speaker Type)
OD Switch
OFF, ON
(Overdrive Switch)
OD Gain
0–127
(Overdrive Gain)
OD Drive
0–127
(Overdrive Drive)
Level 0–127
Speaker Tremolo
Explanation
Type of amp
OLDCASE: a standard electric piano
sound of the early 70s
NEWCASE: a standard electric piano
sound of the late 70s and early 80s
WURLY: a standard electric piano
sound of the 60s
Amount of low-frequency boost/cut
Amount of high-frequency boost/
cut
Tremolo on/off
Hz: The TremRate value is specified
in Hz.
NOTE: The TremRate value is
specified as a note value.
Rate of the tremolo effect
Depth of the tremolo effect
Adjusts the duty cycle of the LFO
waveform used to apply tremolo.
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
Overdrive on/off
Overdrive input level
Degree of distortion
Output volume
58: EP->Cho
L out
L in
EP Amp
R out
R in
Parameter
Type
Bass #
Treble #
Chorus Sw #
(Chorus Switch)
Cho PreDly
(Chorus Pre Delay)
ChorusSync
Cho Rate #
(Chorus Rate)
Cho Depth #
(Chorus Depth)
Cho Bal #
(Chorus Balance)
Sp Type
(Speaker Type)
OD Switch
(Overdrive Switch)
OD Gain
(Overdrive Gain)
OD Drive
(Overdrive Drive)
Level
49
(EP Amp Sim 0 Chorus)
Balance D
Speaker Chorus
Balance D
Value Explanation
Type of amp
OLDCASE:
a standard electric piano
sound of the early 70sA
OLDCASE,
NEWCASE,
NEWCASE:
a standard electric piano
WURLY
sound of the late 70s and early 80s
WURLY:
a standard electric piano
sound of the 60s
-50–+50 Amount of low-frequency boost/cut
Amount of high-frequency boost/
-50–+50
cut
OFF, ON Chorus on/off
Adjusts the delay time from the
0.0–100.0 ms direct sound until the chorus sound
is heard.
Hz:
The Cho Rate value is specified
in Hz.
Hz, NOTE
NOTE:
The Cho Rate value is
specified as a note value.
0.05–10.00 Hz,
Rate of modulation
note
0–127 Depth of modulation
Adjusts the volume balance
between the sound that is sent
D100:0W–
through the chorus (W) and the
D0:100W
sound that is not sent through the
chorus (D).
Type of speaker
LINE, OLD, NEW,
* If LINE is selected, the sound will
WURLY, TWIN
not be sent through the speaker
simulation.
OFF, ON Overdrive on/off
0–127 Overdrive input level
0–127 Degree of distortion
0–127 Output volume
Effects
L out
Balance W
Balance W
R out