Elcometer 205 Operating Instructions Manual page 48

R
To set-up other types of communications software
Elcometer 206
1. Start the communications software.
2. Configure the software using the following
parameters:
Data Bits - 8, Parity - None, Stop Bits - 1,
Baud Rate 1200.
3. Set the communications software COM port to
the port number that the gauge is connected
to.
.
46
Elcometer 206DL
1. Start the communications software.
2. Configure the software using the following
parameters:
Data Bits - 8, Parity - None, Stop Bits - 1,
Baud Rate 1200 (to print a report), or 9600
to transfer data file.
Note: A report
communications program (i.e. HyperTerminal),
or printed to a serial printer using A4 or 8.5" x
11" paper.
3. Set the communications software COM port to
the port number that the gauge is connected
to.
can be printed to a