Elcometer 205 Operating Instructions Manual page 13

ELCOMETER 206DL
Press to switch the gauge on or off.
ON
When switching off, the gauge retains all of its settings.
OFF
If the gauge is idle for 5 minutes, it will switch itself off.
Press to zero the gauge.
PRB
See "Setting the zero point (probe-zero)" on page 16.
0
Press to adjust calibration.
CAL See "Calibration" on page 18.
Press to adjust the features and settings of the gauge (alarm,
scan, units, backlight, and beeper).
MODE
a) Increases values on the display
(press and hold to change values quickly).
b) Scrolls up through features and settings of the gauge and
through files, memory locations, and functions of the data logger.
a) Decreases values on the display
(press and hold to change values quickly).
b) Scrolls down through features and settings of the gauge and
through files, memory locations, and functions of the data logger.
Press to switch on/off data logging (memory).
MEM See "Using the data logger" on page 29.
R
11