Elcometer 205 Operating Instructions Manual page 32

R
4. Press the UP / DOWN arrow keys to scroll to the batch (1-10) that will be used.
5. Press the SEND key once again to select the batch.
The display will flash FILE F-04 (or the selected batch).
6. Press the MEM key, to access the memory locations in the batch selected.
The display will flash the current memory location (L007, L039, etc.), followed by the status of the
memory location. The memory location can contain one of three possible things:
• a measurement that was previously stored
• CLr in the display, indicating that the memory location is empty
• ObSt (obstruct) in the display, indicating that a measurement could not be obtained
7. Press the UP / DOWN arrow keys to advance to the desired memory location.
9.2 STORING A MEASUREMENT
1. Take a measurement and press the SEND key to store a reading in the memory location.
The data logger will then automatically advance to the next memory location in sequential order.
2. Repeat step 1 as required.
9.3 DELETING CONTENTS OF A MEMORY LOCATION
The user may require a memory location that is currently full to be over written. The procedure for deleting
(clearing) the contents of the memory location is outlined in the following steps:
Note: This procedure assumes the steps in 9.1 and 9.2 have been completed, and 9.2 is being repeated.
1. Press the UP / DOWN arrow keys to move to the memory location to be cleared.
30