Flash-To-Pass; Automatic Headlights - If Equipped; Parking Lights; Headlights On With Wipers (Available With Automatic Headlights Only) - Jeep Cherokee 2018 Owner's Manual

• Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function
improperly.

Flash-To-Pass

You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Automatic Headlights — If Equipped
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
clockwise to the last detent (AUTO position) for
automatic headlight operation. When the sys-
tem is on, the headlight time delay feature is
also on. This means the headlights will stay on
for up to 90 seconds after you place the ignition
into the OFF position. To turn the automatic
system off, move the headlight switch out of the
AUTO position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.

Parking Lights

To operate the parking lights, the ignition must
be in the OFF position. Turn the headlight switch
to the "P" position. Then move the multifunction
lever up or down to turn on the left or right side
parking lights.
Headlights On With Wipers
(Available With Automatic
Headlights Only)
When this feature is active, the headlights will
turn on after the wipers are turned on if the
headlight switch is placed in the AUTO position
and programmable feature is set to ON. In
addition, the headlights will turn off when the
wipers are turned off if they were turned on by
this feature.
NOTE:
The Headlights On with Wipers feature can be
turned on or off using the Uconnect System.
Refer to "Uconnect Settings/Customer Pro-
grammable Features" in "Multimedia" for further
information.

Headlight Time Delay

This feature provides the safety of headlight
illumination for up to 90 seconds (program-
mable) when leaving your vehicle in an unlit
area.
To activate the delay feature, place the ignition
in the OFF position while the headlights are still
on. Then, turn off the headlights within 45 sec-
onds. The delay interval begins when the head-
light switch is turned off.
NOTE:
The headlight delay feature is automatically
activated if the customer leaves the headlight
switch in the AUTO position while the ignition is
placed in the OFF position.
If you turn the headlights or parking lights on, or
place the ignition in ACC or RUN, the system will
cancel the delay.
If you turn the headlights off before the ignition,
they will turn off in the normal manner.
NOTE:
• The lights must be turned off within 45 sec-
onds of placing the ignition in the OFF posi-
tion to activate this feature.
• The headlight delay time is programmable
using the Uconnect System, refer to
"Uconnect Settings" in "Multimedia" for fur-
ther information.

Lights-On Reminder

If the headlights or parking lights are on after the
ignition is in the OFF position, a chime will
sound to alert the driver when the driver's door
is opened.
Front And Rear Fog Lights — If
Equipped
The fog light switches are built into the headlight
switch.
To activate the front fog lights, push the
upper half of the headlight switch. To
43