Jeep Cherokee 2018 Owner's Manual page 136

Mass Group Size Class
II – 15 to
25 kg
III – 22 to
36 kg
Key of letters used in the table above:
• (1) = For the CRS which do not carry the
ISO/XX size class identification (A to G), for
the applicable mass group, the car manufac-
turer shall indicate the vehicle specific ISO-
FIX child restraint system(s) recommended
for each position.
• IUF = Suitable for ISOFIX forward child re-
straint systems of universal category ap-
proved for use in the mass group.
• X = ISOFIX position not suitable for ISOFIX
child restraint systems in this mass group
and/or this size class.
Always follow the directions of the child
restraint manufacturer when installing your
child restraint. Not all child restraint systems
will be installed as described here. When
using a Universal ISOFIX child restraint sys-
tem, you can only use approved child re-
straint systems with the marking ECE R44
(release R44/03 or superior) "Universal ISO-
FIX".
Vehicle ISOFIX Positions Table
Front Pas-
Fixture
senger board Rt./Lt.
(1) X
(1) X
To Install An ISOFIX Child Restraint
If the selected seating position has a Switchable
Automatic Locking Retractor (ALR) seat belt,
stow the seat belt, following the instructions
below. See the section "Installing Child Re-
straints Using the Vehicle Seat Belt" to check
what type of seat belt each seating position has.
1. Loosen the adjusters on the lower connec-
tors and on the tether strap of the child seat
so that you can more easily attach the con-
nectors to the vehicle anchorages.
2. Place the child seat between the lower an-
chorages for that seating position. For some
second row seats, you may need to recline
the seat and / or raise the head restraint to
get a better fit. If the rear seat can be moved
forward and rearward in the vehicle, you may
wish to move it to its rear-most position to
make room for the child seat. You may also
move the front seat forward to allow more
room for the child seat.
Rear Out-
Rear Center
N/A X
N/A X
Intermedi-
Intermediate
ate Out-
Center
board
N/A N/A
N/A N/A
3. Attach the connectors of the child restraint to
the lower anchorages in the selected seating
position.
4. If the child restraint has a tether strap, con-
nect it to the top tether anchorage. See the
section "Installing Child Restraints Using the
Top Tether Anchorage" for directions to at-
tach a tether anchor.
5. Tighten all of the straps as you push the child
restraint rearward and downward into the
seat. Remove slack in the straps according
to the child restraint manufacturer's instruc-
tions.
6. Test that the child restraint is installed tightly
by pulling back and forth on the child seat at
the belt path. It should not move more than
25 mm in any direction.
Other Sites
N/A
N/A
133