Turning Lanesense On Or Off; Lanesense Warning Message - Jeep Cherokee 2018 Owner's Manual

applied to the steering wheel, as well as a visual
warning in the instrument cluster display, to
prompt the driver to remain within the lane
boundaries.
The driver may manually override the haptic
warning by applying torque into the steering
wheel at any time.
When only a single lane marking is detected and
the driver unintentionally drifts across the lane
marking (no turn signal applied), the LaneSense
system provides a visual warning through the
instrument cluster display to prompt the driver to
remain within the lane. When only a single lane
marking is detected, a haptic (torque) warning
will not be provided.
NOTE:
When operating conditions have been met, the
LaneSense system will monitor if the driver's
hands are on the steering wheel and provide an
audible and visual warning to the driver when
the driver's hands are not detected on the
steering wheel. The system will cancel if the
driver does not return their hands to the wheel.

Turning LaneSense On Or Off

The default status of LaneSense is "off".
The LaneSense button is located on the switch
panel below the Uconnect display.
LaneSense On/Off Button
To turn the LaneSense system on, push the
LaneSense button (LED turns off). A "Lane-
Sense On" message is shown in the instrument
cluster display.
LaneSense On Message
To turn the LaneSense system off, push the
LaneSense button once (LED turns on).
NOTE:
The LaneSense system will retain the last sys-
tem state, on or off, from the last ignition cycle
when the ignition is changed to the ON/RUN
position.

LaneSense Warning Message

The LaneSense system will indicate the current
lane drift condition through the instrument clus-
ter display.
Base Instrument Cluster Display — If
Equipped
When the LaneSense system is on; the lane
lines are gray when both of the lane boundaries
have not been detected and the LaneSense
telltale is solid white.
System On (Gray Lines/White Telltale)
195