Front Heated Seats - If Equipped - Jeep Cherokee 2018 Owner's Manual

NOTE:
Your key fob can be unlinked to your memory
settings by pushing the set (S) button, followed
by pushing the unlock button on the key fob
within 10 seconds.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the
vehicle is not in PARK, a message will display in
the instrument cluster display.
• To recall the memory settings for driver one,
push memory button number (1) or the unlock
button on the key fob linked to memory
position 1.
• To recall the memory settings for driver two,
push memory button number (2) or the unlock
button on the key fob linked to memory
position 2.
A recall can be canceled by pushing any of the
memory buttons (S, 1, or 2) during a recall.
When a recall is canceled, the driver seat will
stop moving. A delay of one second will occur
before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you cycle the vehicle's ignition to the OFF
position.
• When you cycle the vehicle's ignition to the
OFF position, the driver seat will move about
2.4 inches (60 mm) rearward if the driver seat
position is greater than or equal to 2.7 inches
(67.7 mm) forward of the rear stop. The seat
will return to its previously set position when
you cycle the vehicle's ignition to the ACC or
RUN position.
• The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 of an inch (22.7 mm) forward of the rear
stop. At this position, there is no benefit to the
driver by moving the seat for Easy Exit or
Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later dis-
abled) through the programmable features in
the Uconnect system. Refer to "Uconnect
Settings/Customer Programmable Features" in
"Multimedia" for further information.
Front Heated Seats — If Equipped
The front heated seats control buttons are lo-
cated within the Uconnect system. You can gain
access to the control buttons through the cli-
mate screen or the controls screen.
• Press the heated seat button
the HI setting on.
• Press the heated seat button
time to turn the LO setting on.
• Press the heated seat button
to turn the heating elements off.
If the HI-level setting is selected, the system will
automatically switch to LO-level after approxi-
mately 60 minutes of continuous operation. At
that time, the display will change from HI to LO,
indicating the change. The LO-level setting will
turn off automatically after approximately 45
minutes.
NOTE:
The engine must be running for the heated
seats to operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start,
the heated seats can be programmed to come
on during a remote start.
This feature can be programmed through the
Uconnect system. Refer to "Uconnect Settings"
in "Multimedia" for further information.
once to turn
a second
a third time
35