Enabling And Disabling Parksense - Jeep Cherokee 2018 Owner's Manual

Rear Distance Greater than
(inches/cm) 79 inches
(200 cm)
Arcs — Left None
Arcs — Center None
Arcs — Right None
Audible Alert None
Chime
Radio Volume No
Reduced
NOTE:
ParkSense will reduce the volume of the radio, if
on, when the system is sounding an audio tone.

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
176
WARNING ALERTS
79-59 inches 59-47 inches
(200-150 cm) (150-120 cm)
None None
6th Solid 5th Solid
None None
Single 1/2- Slow
Second Tone (for rear center
(for rear center only)
only)
Yes Yes
ParkSense Switch
When the ParkSense switch is pushed to dis-
able the system, the instrument cluster display
will show the "PARKSENSE OFF" message for
approximately five seconds. Refer to "Instru-
ment Cluster Display" in "Getting To Know Your
47-39 inches 39-25 inches
(120-100 cm) (100-65 cm)
None None
4th Solid 3rd Flashing
None None
Slow Fast
(for rear center (for rear center
only) only)
Yes Yes
Instrument Panel" for further information. When
the gear selector is moved to REVERSE and the
system is disabled, the instrument cluster dis-
play will show the "PARKSENSE OFF" message
for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the
LED will be on.
25-12 inches Less than
(65-30 cm) 12 inches
(30 cm)
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
2nd Flashing 1st Flashing
Fast Continuous
Yes Yes