Jeep Cherokee 2018 Owner's Manual page 37

desired position settings for the driver seat and
side mirrors and a set of desired radio station
presets.
The memory switch is located on the driver's
side door panel. The switch contains three but-
tons, a set (S) button to activate the memory
save function, memory button (1) and memory
button (2). The memory switch allows the driver
to recall either of the two pre-programmed
memory profiles by pushing the appropriate
number button on the switch.
Driver Memory Switch
Programming The Memory Feature
To create a new memory profile, perform the
following:
NOTE:
Saving a new memory profile will erase an
existing profile from memory.
1. Cycle the vehicle's ignition to the ON posi-
tion.
34
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror and radio
station presets).
3. Push and release the set (S) button on the
memory switch, then push memory button
(1) within five seconds. The instrument clus-
ter display will display which memory posi-
tion is being set.
If desired, a second memory profile can be
stored into memory as follows:
1. Cycle the vehicle's ignition to the ON posi-
tion.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror and radio
station presets).
3. Push and release the set (S) button on the
memory switch, then push memory button
(2) within five seconds. The instrument clus-
ter display will display which memory posi-
tion is being set.
NOTE:
• Memory profiles can be set without the ve-
hicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
• To set a memory profile to your key fob, refer
to "Linking And Unlinking The Remote Key-
less Entry Key Fob To Memory" in this
section.
Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory
Your remote keyless entry key fob can be pro-
grammed to recall one of two pre-programmed
memory profiles with a push of the unlock button
on the key fob.
NOTE:
Before programming your key fob you must
select the "Memory To FOB" feature through the
Uconnect system screen. Refer to "Uconnect
Settings" in "Multimedia" for further information.
To program your key fob, perform the following:
1. Cycle the vehicle's ignition to the OFF posi-
tion.
2. Select the desired memory profile 1 or 2.
NOTE:
If a memory profile has not already been set,
refer to "Programming The Memory Feature" in
this section for instructions on how to set a
memory profile.
3. Push and release the set (S) button on the
memory switch, then within five seconds
push and release the button labeled (1) or (2)
accordingly. "Memory Profile Set" (1 or 2) will
display in the instrument cluster display.
4. Push and release the lock button on the key
fob within 10 seconds.