Mnt. 5: Ink Discharge; Mnt. 6: Calibration - MUTOH VJ-626UF Operation Manual

UV Scan 1: Start
UV Scan1 :
UV Scan 2: Scans
UV Scan2 :
UV Scan 3: Post Cure
UV Scan3 :

Mnt. 5: Ink Discharge

Mnt. 5 : Ink Discharge

Mnt. 6: Calibration

Mnt. 6 : Calibration
84

Mnt. 5: Ink Discharge

Performs further UV curing when needed.
Start
When the media is not loaded, "No Media" is displayed, and the screen returns to
the previous screen.
• Application is canceled when the [Cancel] key is pressed for 2 seconds and
more while applying UV light.
Setting
UV Scan1 :
Sets the number of times to apply UV light on the area.
Scans
• The settings here are reflected on "UV Scan1: Start" and "UV Scan3: Post Cure"
only.
Setting
UV Scans:
When it is set to "On", the printer automatically performs post curing to apply
Post Cure
additional UV light after printing.
Setting
Post Cure:
Discharges the ink in the printer. This operation is performed before moving the
printer.
"Transporting the printer" on page 123
Calibrate table height position information to optimize the gap between the
print head and media.
"Calibrating table height" on page 53
Press the [Enter] key to start.
Start
2 / <4> / 8 / 16
4
<> indicates the default setting.
<Off> / On
Off
<> indicates the default setting.