Sleep Mode - MUTOH VJ-626UF Operation Manual

Sleep Mode

1

Sleep Mode

When you are not using the printer, always leave the power on and put the printer into the sleep mode while not in use. If you
do not put the printer into the sleep mode, the ink inside the printer could settle out and/or coagulate, causing poor image
quality or printer failure.
Make sure to follow the instructions on the operation panel to perform daily maintenance.
The following operations are performed during sleep mode.
• Automatic Head cleaning by timer set in the "SetTimer" menu.
• Ink circulation
• "Little Charge"
Important!
To leave the printer in sleep mode for seven days or more, perform followings once a week:
• Check the ink level and replace the relevant ink cartridge if "Ink Low" is displayed.
• Agitate the ink cartridges.
Steps
[1] Make sure that the printer's operating condition is as follows:
• The front cover and the maintenance cover are closed.
• No object including a jig is loaded on the table.
• The remaining ink level is sufficient.
• The waste ink tank has enough space.
Important!
If you are going to use the sleep mode for a prolonged period of time, first empty the waste ink tank.
[2] Prepare items required for daily maintenance.
"Preparing for Daily Maintenance" on page 100
[3]
1
Press!
2
[4]
Menu6:
[5]
SleepMode 1:
[6]
Start Sleep Mode?
Media Set
Low speed
Set Media
Remove Media
Sleep Mode >
Start
Press the [Menu] key.
Press the [ - ] key until "Menu6: Sleep Mode >" appears.
• Press the [>] key.
Press the [Enter] key.
Press the [Enter] key.
Turning the power OFF 29