Table of Contents
Advertisement
Figure 2-3:
2.3
Install thermal insulation
Prerequisites
Make sure you have tightened the fitting nut.
Procedure
1.
2.
3.
4.
Related information
2.4
Rotate the electronics on the meter (optional)
You can rotate the transmitter on the meter up to 90°.
1.
Installation Manual
Capillary viscosity retrofit
Slowly pressurize the system and check for leaks, particularly if the normal operating
temperature is high, or the meter has been fitted cold. Tighten as necessary.
Tighten the nut again, if necessary.
Verify that the system has stabilized and is leak free.
Fit the insulation material.
Temperature gradients and insulation
Using a 4 mm hex key, loosen the cap screw that holds the transmitter in place.
Mounting
17
Advertisement
Table of Contents
