Table of Contents
Advertisement
Planning
4.
10
Figure 1-5:
Power supply wiring terminals
A. 24 VDC
If you have an HFVM with calibration code B (viscosity and density calibration),
perform a Known Density Verification (KDV) check.
Use the Known Density Verification procedure to match the current meter
calibration with the factory calibration. If the meter passes the test, then it has not
drifted or changed during shipment.
For more information on performing a KDV check, see the configuration and use
manual that shipped with the product.
Micro Motion Heavy Fuel Viscosity Meter
Advertisement
Table of Contents
