Switching The Video With A Dissolve Effect (Mix) - Sony BRS-200 Operating Instructions Manual

Switching the Video with a Dissolve Effect (Mix)

Basic operation of a dissolve effect
A gradual transition is done from the current video to the next video while both
videos are overlapped.
The basic procedure for a dissolve is as follows:
Press the MIX button.
Select the video to be output next with the NEXT select buttons.
Execute a transition.
1
Press the MIX button.
The MIX button lights up in orange.
MIX Button
Note
Even if you press the MIX button while the AUTO TRANS button is lit or
the transition lever is not positioned at either end, you cannot change the
wipe transition to mix transition effect. In such a case, wait until the AUTO
TRANS button goes dark or move the transition lever as far as it will go to
either the upper or lower end.
2
Determine the video to be output next then press the NEXT select button to
which the selected video is assigned.
The selected video appears in the preview window.
DSK PIP
AUTO AUTO
N/R REV
MX WIPE
AUTO
CUT
TRANS
Switching the Video with an Effect (Transition Effect)
71