Table of Contents
Advertisement
Basic Setups for the Switcher
Setting the Video Signal Format and Aspect Ratio (Menu Page 951)
50
Basic Setups for the Switcher
This section describes the basic setup items for the switcher. Set up the switcher
before starting video switching or camera-control operations.
This menu is used to set the signal format and the aspect ratio supported by the
switcher.
1
Display menu page 951.
For the procedure for displaying the menu, see "Menu Operation" on page
46.
SYSTEM
FORMAT
SYS MODE
HD
2
Turn the F1 control to select the video signal format you are using under
"FORMAT."
SD: to use SD-SDI signals
HD: to use HD-SDI signals
3
Turn the F2 control to select the frame frequency compatible with the video
signal you are using under "FRAME."
59.94: to use an NTSC signal (vertical frequency: 59.94 Hz) or 1080/59.94i
video signal
50: to use a PAL signal (vertical frequency: 50 Hz) or 1080/50i video signal
4
Turn the F3 control to select the aspect ratio of the display under
"ASPECT."
4:3: to use a display with 4:3 aspect ratio
16:9: to use a display with 16:9 aspect ratio
5
Press the F4 control to confirm the settings selected in steps 2 to 4.
Pressing the F4 control enables confirmation of the settings.
Rebooting the switcher is required after the settings for "FORMAT" or
"FRAME" are changed, and the message "Reboot system? [PAGE] (yes) or
[EXIT] (no)" appears on the display panel.
When only the setting for "ASPECT" is changed, "Save setup data?
[PAGE] (yes) or [EXIT] (no)" appears.
6
Press the PAGE button.
After the switcher has saved the setting data and is rebooted, the changed
settings are enabled.
FRAME
ASPECT
APPLY
59.94
16:9
1/5
Exec
951
Advertisement
Table of Contents
