Connecting A Video Output Device Such As A Camera Other Than A Brc- Series Camera; Connecting A Dvi Signal Output Device - Sony BRS-200 Operating Instructions Manual

Connecting a Video Output Device Such as a Camera Other Than a BRC-
Series Camera

Connecting a DVI Signal Output Device

36
Connecting External Equipment
Connect a camera or video output device equipped with an SDI output to the
SDI IN connector on the switcher.
IN1 5 6 7 8 IN2
CONPOSITE
SDI IN ANALOG IN
1 2 3 4
PGM1 PGM2 AUX1 AUX2
SDI IN SDI OUT
SDI IN 1 to 4
To use an image output from the DVI output on a computer, install the optional
BRSA-20DD1 DVI input board in the IN1 or IN2 card slot on the switcher to
connect to the computer.
5 6 7 8
IN1 IN2
DVI-I IN
SDI IN
1 2 3 4 PGM1 PGM2 AUX1 AUX2
SDI IN SDI OUT
Notes
• To connect a computer that supports an analog RGB output signal only, use a
commercially available conversion cable (D-sub 15-pin y analog DVI).
• The video signal format to be used can be set to "HD" or "SD" under
"FORMAT" on menu page 951 (page 50). When it is set to "SD," small
characters and fine graphics output from a computer may be blurred.
OUT
DVI-I OUT
Y/C
RS-232C
GPI I/O PANEL LAN(10/100) REMOTE
REF IN REF OUT
GENLOCK
Camera, etc. equipped with
an SDI output
BRSA-20DD1 DVI input board (not supplied)
OUT
DVI-I OUT
RS-232C
GPI I/O PANEL LAN(10/100) REMOTE
REF IN REF OUT
GENLOCK
DVI-I IN
Computer
~
AC IN
RS-422
VISCA
~
AC IN
RS-422
VISCA