Table of Contents
Advertisement
Messages and Troubleshooting
Number
Message
1001
Booting Now.
1002
Fan STOP !!
1003
No Communication.
1015
Transferring Data. Please wait. Waiting for a reply from the
1016
Storing Preset Data.
1017
Accessing NV MEM.
1018
Snapshot Data are being
reset.
2001
Storing Preset Data.
2002
Completed.
2005
Different from the expected
camera.
2011
Position Data are being reset.
XXXX
—
144
Messages and Troubleshooting
While you are operating the switcher, a message may appear on the display
panel.
Check this section before consulting your Sony dealer. If the switcher still does
not function properly, write down the message number and consult your Sony
dealer.
Description
The switcher is being booted.
Fan has stopped.
The POWER switch of the
Processor Unit is set to OFF, or the
control cable is not connected
properly.
Processor Unit.
Snapshot data, etc. are being
saved.
Transmitting the data between
frame memory and nonvolatile
memory.
The snapshot data are now being
reset.
Preset data are being saved.
Saving of the preset data is
complete.
Information on camera models
does not match.
The camera positions are now
being reset.
—
Solution
Wait until the message changes.
Turn off the switcher. Check if any object is
blocking the power fan openings. If the fan
still does not function, consult your Sony
dealer.
Set the POWER switch of the Processor Unit
to ON. If the message is displayed when it is
set to ON, check that the supplied control
cable is properly connected between the
PANEL connector on the Processor Unit and
the PROCESSOR connector on the Control
Panel.
Wait until the message changes, and do not
turn off the power.
Wait until the message changes, and do not
turn off the power.
Wait until the message changes, and do not
turn off the power.
Wait until the message changes, and do not
turn off the power.
Wait until the message changes, and do not
turn off the power.
—
The model of the connected camera when
storing the data differs from the model when
recalling the data.
Wait until the message changes, and do not
turn off the power.
If error messages not mentioned on this list
appear, turn the switcher off then back on
after a while. If error messages still remain,
consult your Sony dealer.
Advertisement
Table of Contents
