Component References; Table 4. Mandatory Components; Table 5. Optional Components - ST STM32F10 Series Application Note

AN2586
6.2

Component references

Table 4.
Id Components name
1 Microcontroller
2 Capacitors
3 Capacitor
Table 5.
Id Components name
1 Resistor
2 Resistor
3 Resistor
4 Capacitor
5 Capacitor
6 Capacitor
7 Capacitor
8 Quartz
9 Quartz
10 JTAG connector
11 Battery
12 Switch
13 Push-button
Mandatory components
Reference
STM32F103ZE(T6)
100 nF
10 µF
Optional components
Reference
10 kΩ
390 Ω
0 Ω
100 nF
1µF
10 pF
20 pF
8 MHz
32 kHz
HE10
3V3
3V3
B1
Doc ID 13675 Rev 7
Quantity
1 144-pin package
Ceramic capacitors (decoupling
11
capacitors)
Ceramic capacitor (decoupling
1
capacitor)
Quantity
Pull-up and pull-down for JTAG and Boot
5
mode.
Used for HSE: the value depends on the
crystal characteristics.
1
This resistor value is given only as a typical
example.
Used for LSE: the value depends on the
crystal characteristics.
1
This resistor value is given only as a typical
example.
3 Ceramic capacitor
2 Used for VDDA and VREF.
Used for LSE: the value depends on the
2
crystal characteristics.
Used for HSE: the value depends on the
2
crystal characteristics.
1 Used for HSE
1 Used for LSE
1
If no external battery is used in the
1 application, it is recommended to connect
V externally to V
BAT
2 Used to select the correct boot mode.
1
Reference design
Comments
Comments
DD
23/28